Cutting Tool - EINHELL EHM 1300 Mode D'emploi

Anleitung EHM_1300_SPK1:_
GB
Remove the chips and dust from the
thicknessing table (20) and knife block (23) after
the machine has reached a complete
standstill.
13. Changing the knives (Figure 15/16)
Important: Always pull the mains plug before
changing the knives.
Remove the parallel stop following the
instructions in 9.1 in reverse.
Pull the planing knife cover (12) forwards as far
as possible so that the entire knife block (23) is
exposed.
Undo the clamp screws (c) by turning them
clockwise using the open-ended spanner (17)
supplied. Turn the knife block (23) so that the
latch (22) can be pulled out with the knife (21).
Clean all the relevant parts and the knife slots in
the knife block (23).
Fit the latch (22) with the new knife (21) and
align them with the side of the knife block.
Place the blade adjustment block (15), as shown
in Figure 16, on the surface of the planing table
(14). Ensure that the knife (21) touches both
sides of the blade adjustment block (15).
Tighten the clamp screws (c) counter-clockwise
using the open-ended spanner (17) supplied.
Return the planing knife cover (12) to its original
position so that the knife (21) is covered.
Important!
Only use knives which have been produced
specifically for this machine. If you use other knives
there is a risk of injuries as a consequence of a lack of
control. Avoid over-tightening and the possibility of
the thread becoming detached. If the latch (22) or the
screws have worn out threads they must be
immediately replaced.
14
18.12.2006 8:20 Uhr Seite 14
14. Maintenance (Figure 1/13)
Important: Pull the mains plug before starting and
maintenance work.
14.1 Machine
Lubricate the following parts periodically after around
10 hours of service:
Bearings for the feed/discharge rollers and anti-
kick claws (24)
Bearings on the belt roller and pulley
Grub screws to adjust the height of the
thicknessing table (20)
Use only dry lubricant.
The feed table (13), planing table (14), thicknessing
table, feed/discharge rollers and anti-kick claws (24)
must be kept free of resin at all times. Soiled
feed/discharge rollers or anti-kick claws (24) must be
cleaned without delay.
To prevent the motor overheating, the dust that
accumulates in the ventilation openings must be
removed at regular intervals.
Improve the smooth running of the tables by applying
lubricant at regular intervals.

14.2 Cutting tool

Resin must be cleaned off the knife (21), latch (22)
and knife block (23) at regular intervals. Clean these
components with an appropriate resin remover.
15. Troubleshooting (Figure 1)
1. The machine cannot be switched on:
No mains power. Check the power supply.
Carbon brushes worn. Have the carbon brushes
replaced by an electrician.
2. The machine cuts out when idling:
Power failure (check fuses). Have the fuse
replaced by an electrician.
3. The machine cuts out when planing:
Blunt knife or feed speed too high. Replace the
knife or reduce the feed speed.
4. Loss of speed when planing:
Cutting depth too deep. Reduce cutting depth.
Feed speed too high. Reduce feed speed.
Blunt knife. Replace knife.