Kreg KHI-PULL-INT Guide D'utilisation page 5

Chuck the Drill Bit into an electric drill,
remove the cap from the drill bit and install
the Drill Guide/Drill Bit in the Base, turning
the Drill Guide clockwise until it engages the
detents. Switch on the drill, wait until it comes
up to full speed and drill the hole. Stop when
the Stop Collar contacts the Drill Guide. With
the drill still running, withdraw the bit and turn
off the drill. Remove the Drill Guide/Drill Bit
from the Base.
ATTENTION Always use two clamps to secure
the jig.
Chuck a ⁄ " [1.5mm] drill bit into the electric
1
16
drill. Insert the bit into the hinge-screw drill
guides on the Base and drill pilot holes into
the door. Unclamp the Base and move it to
the next hinge location.
ATTENTION Most hinge screws require a
[1.5mm] pilot hole. Check the pilot-hole size for
your hinge screws before drilling.
ATTENTION To avoid accidentally drilling through
the door when drilling the hinge-screw pilot holes,
wrap a piece of masking tape around the drill bit
⅞" [22mm] from the tip (½" [13mm] for the Base
thickness plus ⅜" [10mm] for the depth of the
pilot hole).
Follow your hinge manufacturer's instructions
for positioning the hinge-mounting plates in
the cabinet.
Using the Jig
Masking
tape marks
drilling depth
⁄ "
1
16
Hinge screw
drill guides
4