SEVERIN PG 8510 Mode D'emploi page 15

- before fi lling the grill pan with water,
- after use,
- in case of any malfunction, and
- during cleaning.
∙ The use of an extension-lead reel causes
a loss of power, possibly combined with
a subsequent heat build-up in the cable.
It is therefore necessary to unwind the
cable completely if a cable reel is used.
Make sure that the reel is approved for
outdoor use by the manufacturer.
∙ Never move the grill while it is in use
or still hot. Always allow the appliance
suffi cient time to cool down before
carrying, transporting or storing it. Pour
out any remaining water after use.
∙ Ensure that the grill is not stored
outdoors, or in any other location where
it might be subjected to extremes of
temperature or high humidity.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This product complies with all binding CE
labelling directives.
Grill assembly
The barbecue grills are available in different
confi gurations.
When assembling the grill, always refer to
diagram A corresponding to your particular
grill model. Follow the steps below:
∙ Place the grill pan inside the plastic
housing.
∙ Place the heating element into the grill
pan.
∙ Fit the grill rack on top.
For some grill models, we also offer an
additional base stand:
Assemble the base stand according to the
schematic diagram B. Place the grill onto
the stand in such a way that the small feet
under the grill connect in the top of the
vertical legs of the base stand; ensure that
the grill and base stand are placed in a safe
and stable position.
The power cord should be routed in such a
way that no one is likely to trip over it.
Heating element
The junction box contains a safety switch.
Place the grill pan into the plastic housing
fi rst, and then fi t the heating element inside
the grill pan and housing. The safety switch
is activated automatically when the heating
element has been properly fi tted. If not fi tted
correctly, the appliance cannot be switched
on.
Before using for the fi rst time
∙ Remove any packaging materials and
stickers from the appliance.
∙ Clean the grill rack and grill pan with
warm soapy water; dry thoroughly
afterwards.
∙ Assemble the grill as described above.
∙ Fill the grill pan with water up to the 'Max'
marking.
∙ Insert the plug into a suitable earthed
power-outlet.
∙ Let the grill heat up for approximately
5 minutes without any food on the
rack. This will lessen the smell typically
encountered when fi rst switching on
a new grill (a slight smell and a little
smoke may be emitted - ensure suffi cient
15