Shelf Instructions - Danby Silhouette SBC051D1BSS Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 23.8 inches (60.5 cm) wide
by 34.1 inches (86.6 cm) high by 23.7 inches
(60.2 cm) deep.
FRONT VENT
This appliance is front breathing. Do not block the
front air vent as this will result in high operating
temperatures, higher energy usage and possible
system overheating and failure.
LEVELING INSTRUCTIONS
There is an adjustable leg on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level. It is important that the
appliance is level to minimize noise and vibration.
To level the appliance:
1. Move the appliance to its fi nal location.
2. Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the cabinet.
3. Slowly turn the leveling leg clockwise until the
appliance is level.

SHELF INSTRUCTIONS

To remove a shelf from it's locked position, tilt the
shelf as shown and then pull outward.
To reinstall the shelf, ensure it is resting securely on
the support brackets and push inward until it locks
into place.
Note: The bottom shelves in both compartments are
not secured in place. Do not attempt to pull on these
shelves when they are stocked with bottles or cans.
3