Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY: When using your refrigerator, follow the precautions listed below.
Please ensure that component parts shall be replaced with like components and that servicing shall be done
by factory authorized service personnel, so as to minimize the risk of possible ignition due to incorrect parts
or improper service.
CAUTIONS
•
Storing too much food or opening the door too frequently will cause the refrigerator to use more electrical con-
sumption w hich can lead to a malfunction.
•
Do not place objects on top of the unit that are heavy, sharp or corrosive.
•
Anytime the power is disconnected from the unit wait 5-10 minutes before plugging back in.
•
Do not store bottled drinks in the freezer, in order to keep the bottle from breaking and damaging the refrigerator.
•
Open the door as little as possible during power failures.
•
When defrosting, never use any sharp or metallic objects to remove the frost on the surface of the evaporator as it
will damage the evaporator.
•
Do not touch foods and containers in the freezer compartment with wet hands.
•
This unit is not designed for outside installation, including installation anywhere that is not temperature controlled
(including garages, porches, carports, etc.).
FOR HOUSEHOLD REFRIGERATING APPLIANCES
•
Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, close it as
soon as possible.
•
Every now and then check if the appliance is sufficiently ventilated (adequate air circulation behind the appliance).
•
For household refrigerating appliances the recommended setting for the thermostat is the medium setting.
•
Before loading the appliance with packages of fresh foods, make sure they are cooled to ambient temperature.
•
Ice and frost layers increase energy consumption, so defrost the appliance as soon as the layer is 3-4 mm thick.
•
If it is an outer condenser, the rear wall should always be clean, free of dust or any impurities.
Installation Instructions
LOCATION
Do not tilt the refrigerator more than 45° from the upright position during movement.
1) Select a place with a level surface.
2) Allow 5 cm / 2 inches of space all around the refrigerator.
3) Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will cause higher
electricity consumption.
4) Avoid damp places. Too much moisture in the air will cause frost to form very quickly on the evaporator, and your
refrigerator will have to be defrosted more frequently.
Note: Before plugging in the unit, let it stand upright for approximately 2 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during transportation.
SAVE THESE INSTRUCTIONS!
Remove exterior and interior packaging, wipe the outside thoroughly with a
soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the
unit in a narrow recess or near any heat source, direct sunlight, or moisture.
Let air circulate freely around the unit. Keep the rear of the refrigerator 5
cm / 2 inches away from the wall.
4
Publicité
Table des Matières
Dépannage
