Dryer Operation - Maytag BRAVOS MGDB850 Guide D'utilisation Et D'entretien

2. Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove
the screw located in the lower right corner of the cover. Remove the cover.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

Dryer Operation

Dryer will not run
■ Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
■ Was a regular fuse used?
Use a time-delay fuse.
■ Is the dryer door firmly closed?
■ Was the Start/Pause button firmly pressed?
Large loads may require pressing and holding the Start/Pause button for 2-5 seconds.
No heat
■ Has a household fuse blown, or has a circuit breaker tripped?
The drum may be turning, but you may not have heat. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
Unusual sounds
■ Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a thumping sound during the first
few minutes of operation.
3. Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only.
4. Plug in dryer or reconnect power.
TROUBLESHOOTING
to possibly avoid the cost of a service call...
In U.S.A. www.maytag.com/help - In Canada www.maytag.ca
■
■
■
■
■
■
Replace the cover and secure with the screw.
Is a coin, button or paper clip caught between the drum and front or rear of the dryer?
Check the front and rear edges of the drum for small objects. Clean out pockets before
laundering.
Is it a gas dryer?
The gas valve clicking is a normal operating sound.
Are the four legs installed, and is the dryer level front to back and side to side?
The dryer may vibrate if not properly installed. See the Installation Instructions.
Is the clothing knotted or balled up?
When balled up, the load will bounce, causing the dryer to vibrate. Separate the load
items and restart the dryer.
Dryer displaying code message
"PF" (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Depending on the length of the power outage, you may be able to resume the cycle by
simply pressing START/PAUSE; otherwise, press POWER/CANCEL and then start a new
drying cycle.
"F" Variable (F1, F2, F20, etc.) service codes:
Call for service.
25