Cleaning And Maintenance; Transportation And Storage - MSW IR-DRYER3000.2 Manuel D'utilisation

NUMBER DESCRIPTION
1 Vertical support post
2 Upper cap
3 Plastic trim
4 Left clamp
5 Support frame
6 Terminal strip
7 IR unit
8 Plastic lever for adjusting angles
9 Connector
10 Right clamp
11 Handle
12 Bottom support rod
13 Top support rod
REPLACING LAMPS
1. Dismantle the IR unit
3. Remove the housing from both
sides of the IR unit.
5. Then remove the bulb and install
a new one with similar parameters.

TRANSPORTATION AND STORAGE

During transport, the machine should be protected from shaking, crashing and turning upside down. Store it
in a properly ventilated place with dry air and without any corrosive gas.
14
NUMBER DESCRIPTION
14 Actuator
15 Actuator bracket
16 Front wheels
17 Support frame
18 Rear wheels
(with brake mechanism)
19 Flange
20 Cover
21 Control transformer
22 On/Off switch
23 Handle
24 Cover
25 Control panel
2. Remove the protective mesh
4. Remove the covers from both
sides of the IR unit.
6. Then assemble the IT unit and the device
in reverse order to dismantling.
Rev. 05.06.2017

CLEANING AND MAINTENANCE

• Disconnect the machine from the electricity when cleaning it.
• Use cleaner without corrosive substances to clean surface.
• After cleaning, all parts should be able to dry before the machine is to be reused
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
• Never spray the device with water jets.
CHECK REGULARLY DEVICE
Check regularly whether the device is damaged. If it should be damaged, please stop using it immediately and
contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to solve your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 05.06.2017
15