Control Panel Description; Operating Principle; Assembling The Device - MSW IR-DRYER3000.2 Manuel D'utilisation

CONTROL PANEL DESCRIPTION

IR-DRYER3000.2
1
2 3
4
1. Time display
2. Button for setting time "+"
3. Button for setting time "+"
4. Lamp selection
5. Start
5 6
6. Stop
IR-DRYER3000.1
1. Time display
2. Temperature display
1
3. Work mode selector: pulsating
2 4. Work mode selector: constant
5. Buttons for setting time" "+" and "-"
6. Buttons for setting temperature: "+" and "-"
4
3
5
7. Start
9 6
8. Stop
5
10 6 9. Emitter selector: emitter 1
7
10. Emitter selector: emitter 2
11
8
11. Emitter selector: emitter 3
IR-DRYER2000.1
1
1. Voltmeter
2. Time display
2
3. Button for setting time: "+"
4. Button for setting time: "-"
3
4
5/6. Emitter selector
7. Function: RUST PROOF PRIMER
5 6
8. Function: PRIMER
7 8
9. Function: PRIMARY FILLER
9 10
10. Function: TOP COAT
11 12
11. Function: SECONDARY FILLER
12. Function: VARNISH
14
13
13. Start
14. Stop

OPERATING PRINCIPLE

1. Assemble the device in accordance with the diagram and position it correctly.
2. Then connect to power supply and turn on.
3. Use the buttons to set the device operating time.
4. IR-DRYER3000.1 and IR-DRYER2000.1 models have a temperature adjustment feature. Use buttons to
set the temperature on the IR-DRYER3000.1 model, and use function buttons to set the temperature
on the IR-DRYER2000.1 model.
5. Then select the emitters to be switched on.
6. Once the device has been positioned correctly, activate it using the start button. To deactivate the
emitters, press the stop button. When not in use device off and disconnect it from the power source.
To adjust the position of the IR unit, pull the lever on the frame of the device. To adjust the angle of the
emitter, loosen the levers on the sides, align at the required angle and tighten.
12
IR-DRYER2000.2 | IR-DRYER1000
2
4
CONTROL PANEL DESCRIPTION
ON/OFF
OPERATING PRINCIPLE
1. Assemble the device in accordance with the diagram and position it correctly.
2. Then connect to power supply and turn on.
3. Use the knob to select the time foe which the device is to be active.
4. When not in use device off and disconnect it from the power source.

ASSEMBLING THE DEVICE

Assemble the device in accordance with the overview diagram below.
3
2
1
25
24
23
22
21
20
19
18
Rev. 05.06.2017 Rev. 05.06.2017
2
1
1
Device description
1.
2.
3
3
3.
4
4.
ON/OFF switch
TIMER – Time settings
TIMER
7
6
5
4
8
9
10
11
12
13
14
15
16
17
Emitters
Support post
Bottom support frame
Wheels
13