Reference Standards; Identification - Rating Plate Data (Fig. 2); Conditions Of Use - Arneg HPF Manuel D'installation Et De Service

5. Reference standards

The reference standards according to which the unit has been tested and approved are:
- "Machinery" Directive:
- Low Voltage Directive:
- Electromagnetic Compatibility Directive:
- PED Pressure Equipment Directive:
- Standards for refrigerating systems and heat pumps:

6. Identification - Rating plate data (Fig. 2)

The unit is equipped with a rating plate with all the following data. Keep a copy of the data in the office of the person
in charge of supervision and maintenance of the systems:
1 Trade name of the product
2 Product code
3 Serial number
4 Supply voltage - Number of phases - Frequency of power supply
5 Maximum power absorbed
6 Maximum current absorbed
7 Refrigerating power output
8 Maximum transitory current absorption, which can be reached by the machine
9 Type of refrigerating gas
10 Maximum allowable pressure
11 Reference evaporation temperature
12 Reference condensation temperature
13 Order number with which machine was produced
14 Order number with which production on machine was started
15 Year of production
16 CE marking with identification number of notified body, according to Directive 97/23/EC
For identification of the unit, when requesting service, you should supply:
- product name
- serial number
- order number

7. Conditions of use

HPF condenser units are designed and produced so as to guarantee the maximum safety during installation and
use.
To ensure the safety and correct operation of the unit, follow the instructions in the manual scrupulously, and do not
perform any operations that could cause malfunctions and risks for the operator.
We recommend strict respect of the following procedures:
- Refer to the technical documentation for any operation to perform on the unit. Any operation not described in
the manual must be authorized by the manufacturer.
- The "Engine Room" should be large enough and suitable for the unit in respect of standards EN 378-2.
- Before performing any operation make sure to:
- Shut off the power to the machine using the circuit breaker on the control panel;
- Check that there are no parts under pressure or power;
- Check that the temperatures of the various parts cannot cause burns;
- Post a sign on the control panel to indicate the state of the unit and prevent undesired startups.
05060044 00 15/07/2004
(Fig. 2 - 1);
(Fig. 2 - 3);
(Fig. 2 - 13).
89/392/EEC and subsequent amendments
73/23/EEC and subsequent amendments
89/336/EEC and subsequent amendments
97/23/EC and subsequent amendments
EN 378 (1, 2, 3, 4)
HPF
English
17