Simple Reset; Complete Reset; Cleaning & Maintenance - Häfele Dialock FT 120 Notice D'emploi

12. Reset

12.1 Simple reset

12.2 Complete reset

13. Cleaning / maintenance
13.1 Cleaning
13.2 Servicing /
maintenance
The simple reset can be triggered with the aid of a paper clip. The status of the jumpers at
terminal 3 and 4 is read in and the operating mode is set accordingly. Results:
• The programming key and the clearing key are cleared.
• User keys, special key and macros remain stored.
For step-by-step instructions „Simple reset" see illustrations starting on page 56.
NOTE
Re-teach the programming key and clearing key directly after completing the reset
(see chapter „5. Start-up") without pulling the mains plug!
The complete reset can be performed with the aid of a paper clip or a separately ordered reset key.
The entire stored content is cleared and the factory status is restored in a complete reset. Results:
• The activated operating mode (latch bolt lock operation, dead bolt lock operation) are retained.
• All keys, logs, macros, parameter settings are cleared.
For step-by-step instructions „Complete reset - Version 1" or „Complete reset -
Version 2" see illustrations starting on page 57.
NOTE
Do not pull the mains plug after completing the reset!
Re-teach the programming key and clearing key directly after completing the reset
(see chapter „5. Start-up")!
NOTE
Damage to product due to incorrect cleaning!
> Only clean the parts listed below.
> Only use the cleaning agents listed below.
• Wipe visible installed antenna surfaces with a soft cotton cloth that is moistened with some
alcohol, if necessary.
The product is maintenance-free.
NOTE
Damage to product due to incorrect maintenance!
> Never unscrew the housing of the product components.
> Do not carry out repairs.
> Contact the manufacturer in the event of damage / malfunctions.
> If parts have to be replaced, always use original spare parts from Häfele.
17