Burda PERFECTCLIME PCE05 Montage Et Mode D'emploi page 12

C P O
HANGE UMP IL
• Open the cover.
Unscrew the oil drain plug.
• Please use a container or a tray to catch oil as it comes
out of the pump. When the oil stops draining, please
refasten the plug.
• Take off the oil inlet cover. Carefully refill 270ml of motor
oil of #30 or #40 weight and make sure the oil level is up to
the middle of the oil window.
• Refasten the oil inlet cover.
A Please do not change oil immediately after
TTENTION
using the misting system. The oil will be hot and might
cause personal injury.
• If the oil is below the middle of the oil window, please
refill the oil up to the middle.
• If the oil is above the middle of the oil window, please be
aware the oil may splash out and cause the misting system
to malfunction over time.
C
LEAN THE FILTER
• Loosen the filter cup.
• Remove both filter meshes from the base.
• Please remember which ends are the tops and which are
the bottoms.
• Use water and a soft brush to clean the mesh.
• If the filter meshes are not reassembled correctly, the filter
will not close properly.
C
LEAN THE NOZZLE
• Open the nozzle by unscrewing the spray tip from the
nozzle body.
• Clean the ball valve and area around the orifice.
C
LEAN THE PIPES OR HOSES
• Open the ball valve at the end of the misting line.
• Run the misting system 2 to 3 minutes.
• Close the ball valve.
T
URNING OFF THE MISTING SYSTEM AND STORAGE
• Turn off the power on the machine and unplug from the
electrical outlet.
• Turn off the water supply.
• If the system will not be used for a long period, please
follow these additional instructions.
• Unfasten the supply hose, inlet hose and discharge hose.
• Open the cover.
• Clean the filter to prevent dirt solidifying and algae
growth.
• If your model has a reservoir, please drain it and refasten
the drain plug.
• Close the cover and tighten the knobs securely.
• Unplug the power cable from the socket.
• Store the unit in a cool dry place away from hazardous
conditions.
GB