Prefl Ight Checklist; Model Assembly - Horizon Hobby Plug-N-play Pulse 15e Manuel D'utilisation

EN
Prefl ight Checklist
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the fl ight battery.
4 Fully assemble the airplane.
5 Install the fl ight battery in the aircraft (once it has been fully charged).
6 Check the Center of Gravity (CG).
7 Bind the aircraft to your transmitter.
8 Make sure linkages move freely.

Model Assembly

Horizontal Stabilizer Installation
1. Slide the horizontal stabilizer (A) into the slot. Ensure that the elevator
control horn is facing down.
2. Rotate the horizontal stabilizer in the fuselage slot so the z-bend of the
control linkage (B) enters the outermost hole of the elevator control horn
(C) as shown.
Tip: Move the elevator servo arm to full travel. This moves the pushrod
rearward to give the most room to install the horizontal stabilizer. Make sure
to center the servo again before fl ight.
3. Fully slide the horizontal stabilizer into the slot and secure it in the fuse-
lage using 2 screws (D).
When needed, disassemble in reverse order.
4
9 Perform the Control Direction Test with the transmitter.
10 Perform the AS3X Control Direction Test with the aircraft.
11 Adjust fl ight controls and transmitter.
12 Perform a radio system Range Test.
13 Find a safe open area to fl y.
14 Plan fl ight for fl ying fi eld conditions.
D
A
C
B
Pulse 15e
™