Horizon Hobby Plug-N-play Pulse 15e Manuel D'utilisation page 7

Model Assembly Continued
Landing Gear Installation (Tail Dragger Option)
1. Install the main landing gear assembly (A) on the fuselage as shown using
2 screws (B).
2. Install the tail wheel (C) in the rudder mount as shown. Secure it in place
by tightening the set screw (D) on the flat spot of the strut with a 1.5mm
hex wrench.
L di Landing Gear Installation (Tricycle Gear Option) G I t ll ti
1. Remove the 2 wing screws (A) from the wing and install the main gear (B)
on the wing.
2. Secure the main gear and wing into place with the 2 wing screws.
3. Install the nose gear (C) in the nose, tightening the set screw (D) on the fl at
spot of the strut with a 1.5mm hex wrench.
(T i l G O ti )
A
D
C
C
D
EN
B
A
B
7