Background Information; Limitations Of Liability; Intended Use - GYS SPOT LIFT EASY Notice Originale

Translation of the original notice
Thank you for choosing GYS! In order to gain maximum satisfaction from your SPOT LIFT EASY and for your safety,
please read this manual carefully before first use and keep it carefully for future reference.

BACKGROUND INFORMATION

These operating instructions contain important information for installation in order to ensure proper commissioning and
operational safety of the SPOT LIFT EASY. Complying with the documentation reduces risks and extends the life of the
product. This manual contains a form to certify regular security checks. Use the «Regular Security Check» form to archive
the checks. (It is advisable to make a copy of the form before filling it in for the first time.)
Installation and control:
Work ensuring safety and security controls are reserved exclusively for specially trained persons. These persons are
referred to in this documentation as experts and/or authorised persons.

LIMITATIONS OF LIABILITY

The SPOT LIFT EASY is a mobile hydraulic column jack designed in compliance with standard EN 1494. All data and
advice in this manual have been collected in accordance with its applicable standards and regulations and our extensive
knowledge and experience.
The manufacturer cannot be held responsible in case of material and physical damage that could lead
to death by:

INTENDED USE

The SPOT LIFT EASY is intended for the repair of cars and leisure vehicles. It allows a vehicle to be lifted by gripping
under a wheel (or by the lower body frame as an option*). Rated load is 1100 kg.
The SPOT LIFT EASY may only be used by persons who have read and understood the operating instructions.
A safety perimeter must be defined in which no one must be present during the lifting operation.
The lifting of persons or other objects is not allowed. No one must be inside the vehicle to be lifted.
The SPOT LIFT EASY must be used inside a work room and protected from bad weather (wind, rain and temperatures
below 5°C).
The operating temperature range is between 5°C and 50°C maximum. In case of prolonged storage in a place where the
temperature is below 0°C, allow at least 12 hours before use the SPOT LIFT EASY by storing it in the workplace.
Do not use in excessively humid conditions.
Never use the lift on uneven surfaces / slopes. The ground must be flat and strong enough to prevent the wheels from
sinking under the weight of the load.
It is forbidden to use the jack on a boat/ship (stability problem).
Remove any grease and oil stains that may cause the vehicle to slide.
Work underneath the vehicle is strictly forbidden.
Vehicles should only be lifted by the wheels and by the lifting points (optional) recommended by the vehicle manufacturers.
Make sure that the SPOT LIFT EASY does not come into contact with areas close to the airbag activation sensors during
and after the lifting.
In the event of a violent impact on the load-bearing and/or structural elements of the SPOT LIFT EASY, it is imperative
to take the product out of service and contact your dealer or the manufacturer in order to assess the damage before
putting it back into service.
12
- Non-compliance with the operating instructions
- Improper or dangerous use
- Employment of unskilled persons
- Unauthorized transformation on the jack
- Insufficient maintenance
SPOT LIFT EASY
EN