Exit Galaxy Mode D'emploi page 11

8
Install the wall-mount frame (38) to the upper arm (7) using two M12X65mm bolts
(A19), four M12 plastic washers (D8),and two M12 locknuts (C4).
Do not tighten the bolt yet.
9
Install the wall-mount frame (38) to the short arm (42) using an M12X225mm bolt
(A22), two M12 washers (16), and an M12 locknut (C4).
Make sure all the bolts in the steps above are tighten. Do not over tighten
the locknuts on the pivot parts.
10
1. Assemble the upper adjustment pole (44) with middle adjustment pole (45).
2. Then, attach the bottom adjustment pole (46) to the middle adjustment pole
(45).
11
1. First, the wall-mount frame (38) should be affixed using M8X80mm steel bolts
(A25).
2. Then, assemble washers, spring washers and nuts. Install the wall-mount frame
(38) with four M8 washers (D2) and four M8X60mm wooden screws (A24) into
the wall.
Note: Make sure all the bolts in the steps above are tighten.
12
Instructions
A. Elevating the backboard height.
Push the rim upwards using the adjustment pole to increase the backboard height.
B. Lowering the backboard height:
1. First, push the adjustment bracket using the adjustment pole so that the back-
board will descend to the lowest point.
2. Then, push rim upwards using the adjustment pole to increase the backboard
height to a spot you prefer.
Congratulations! Your EXIT Galaxy Basketball hoop
is now fully assembled (put together).
Galaxy
Basketball Systems
11