Limora 6336 Instructions De Montage page 7

Wiring
The switch has three brass terminals with slotted set
screws. The back of the switch has the same three
letters found on original examples.
The ‚F' terminal is always the source of power. The ‚L'
and ‚R' logically mean left and right, but that is only
true for some applications. Ideally, you will simply
duplicate the connections on your existing switch
by transferring one wire at a time. If the switch was
removed and the wires disconnected long ago, you
can determine how the wires should be connected
with an ohm meter. Hold the switch exactly as it will
be when installed, using the flats on the nose of the
switch to help position the switch. With the lever in
the off position (pointing straight up in some appli-
cations, straight down in others), connect the leads
of an ohm meter to the ‚F' and ‚L' terminals. Move
the lever to the left, as if you were signaling a left
turn. If the meter shows continuity, ‚L' means Left
in your application. If there is no
continuity, move the lead on the
‚L' terminal to the ‚R' terminal and
move the lever to the left again.
If there is continuity now, the ‚L'
means right and ‚R' means left as
far as the wiring is concerned.
– 7 –