Limora 6336 Instructions De Montage page 5

The pneumatic turn signal switch assembly was
fitted to a variety of classic British cars. It was
an ingenious solution to the need for a simple
self cancelling turn indicator.It was mounted on a
bracket under the fascia, or through it. The threaded
„nose" of the switch has a flat on two sides which
corresponds to the shape of the hole in the fascia for
some applications. The flats orient the switch in a
particular way so the handle will point straight up (or
down) in the off position.
The knurled chrome ring (which has the distinctive
cross-hatch pattern) on the threaded „nose" secures
the switch with a large internal toothed lock
The handle or lever
Transfer your original black or white plastic lever;
it will fit over the end of the brass hexagonal shaft.
The lever is secured with a small screw. When wired
properly, moving the lever to the right activates the
right handturn signals, and vice versa. If you need a
new lever, contact your distributor.
Caution:The housing is made from thermosetting
resin like the genuine part. Please be carefull and
don't cant the lock nut. Tighten only by hand, don't
use tools: the threaded nose may break.
– 5 –