Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing d.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
To change the display
Press DISPLAY on the main unit, or press DISPLAY while
pressing SHIFT on the remote control.
The display changes in the following order:
1 Level indicator
2 Frequency of the tuned station
(Example: FM 90.00MHz)

PRESETTING STATIONS

d
2
3
1
The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in a preset station directly.
1 Press TUNER/BAND repeatedly to select a band.
2 Press f or g to select a station.
3 Press a to store the station.
A station is assigned a preset number for each band in
consecutive order beginning from 1.
4 Repeat steps 1 to 3.
The next station will not be stored if a total of 32 preset stations
have already been stored.
If you try presetting more than 32 stations, "PRST FULL" is
displayed.
10
ENGLISH
TUNER/BAND
0-9,+10
Preset number
Frequency
PRESET STATION TUNING
1 Press TUNER/BAND to select a band.
2 Press d.
Each time the button is pressed, the next ascending preset
number is selected.
Tuning by preset number
1 Press TUNER/BAND to select a band.
2 Press the numbered buttons on the remote control to select a
preset number:
Example:
To select preset number 10, press +10 and 0.
To select preset number 15, press +10 and 5.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
s, and press a within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
NOTE
If there is a long period of power failure or disconnection of AC
cord, the presetting of the stations is canceled. In this case, preset
again.

Publicité

Table des Matières
loading

Table des Matières