Inficon Extrima Manuel De L'utilisateur page 53

Certificate of Conformity: IECEx SP 07.0002X
Certificate No.:
Date of Issue:
Manufacturer:
Manufacturing location(s):
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and
found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products
covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This
certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents
as amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified
documents, was found to comply with the following standards:
IEC 60079-0 : 2004
Edition: 4.0
IEC 60079-11 : 2006
Edition: 5
IEC 60079-26 : 2006
Edition: 2
This Certificate does not indicate compliance with electrical safety and performance requirements other than those
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
GB/SIR/ExTR07.0085/00
GB/SIR/ExTR09.0206/01
GB/SIR/ExTR10.0252/00
SE/SP/ExTR07.0001/00
Quality Assessment Report:
SE/SP/QAR07.0002/00
http://iecex.iec.ch/iecex/iecexweb.nsf/CoCHistory/IECEx%20SP%2007.00022
IECEx Certificate
of Conformity
IECEx SP 07.0002X
2010-12-10
Adixen Scandinavia AB
Westmansgatan 49
Box 76
SE-581 02 Linköping
Sweden
Electrical apparatus for explosive gas atmospheres - Part 0: General requirements
Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
Explosive atmospheres - Part 26: Equipment with equipment protection level (EPL) Ga
expressly included in the Standards listed above.
INFICON - Manuel de l'utilisateur Extrima
Page 2 of 5
Issue No.: 2
Page 2 of 4
2010-12-29
FR
53