Installation Instructions - afx light FOG1500W-T Manuel D'utilisation

IMPORTANT NOTES
Before operation, please make sure the local mains power matches the rated input voltage. Please refer to the rating
label on the rear side of the unit.
Before filling the fog liquid, please unplug the unit from the mains.
In order to prevent short circuits, please don't let fog liquid flow into the inner part of the machine before filling, you
can also take out the liquid bottle and fill in the fog liquid outside the unit.
The fog machine must be installed on the ground. It's not allowed to slope the unit or place it upside down
After use, switch the fog machine off and unplug it from the mains
The fog machine isn't waterproof. If moisture or fog liquid enters inside the machine, you must unplug it immediately
from the mains and contact your dealer.
It's forbidden to spray directly towards persons. Keep far away from flammability and explosive objects
The fog spray is very hot, please keep a distance of at least 5 meters when using it
Please don't touch the surface of the fog machine during the use because the housing will reach 40-80°C
When the machine doesn't work, please check if the fuse is burnt out or not. If it is, replace it by an identical fuse,
find out the fault and restart the machine. But please note: the repair must be handled by professional.

INSTALLATION INSTRUCTIONS

Install the fog liquid
Unscrew the cap of the fog liquid bottle and fill the fog liquid. After filling, screw tight the cap of the fog liquid bottle to
avoid fog liquid leaking out.
Power Supply and Signal Cable Connection
1. Mains Power connection
The exclusive plug should be used between the connection of unit and power. Please ensure that the rated voltage
and frequency are accordance with the power supply. The required input voltage and frequency are: 220-240Vac –
50/60Hz
We suggest that every fog machine has an independent switch so that you can turn on or turn off the fog machine
randomly.
Note: the ground wire (yellow/green double-color wire) must be safely connected, the electronic installation must be
in accordance with the related standards
CAUTION: When installing the device, make sure there is no highly inflammable material within a distance of
min.5m!
2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of the slave unit.
Connect the DIGITAL OUT socket of the master and the IN socket of the slave unit, then, connect the OUT socket to
the IN socket of the next light. Ordinal to connect all units as below:
1 2 3
I N I N I N
O U T O U T O U T
© Copyright LOTRONIC 2018 FOG1500W-T Page 3