Electrical Requirements; Installation Instructions; Unpack The Wine Cellar - Jenn-Air JUWFL242HL Guide D'utilisation Et D'entretien

ELECTRICAL REQUIREMENTS

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.

UNPACK THE WINE CELLAR

WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
Before using your wine cellar, all packaging materials
should be removed and the interior should be cleaned.
Remove tape and glue residue from surfaces before
turning on the wine cellar. With your fingers, rub a
small amount of liquid dish soap over any adhesive
and wipe with warm water to remove.
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape
or glue. These can damage the surfaces of your wine
cellar. For more information, refer "Wine Cellar Safety"
section.
8

INSTALLATION INSTRUCTIONS

Before you move your wine cellar into its final location, it
is important to make sure you have the proper electrical
connection.
RECOMMENDED GROUNDING METHOD
A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your wine cellar be provided.
Use an outlet that cannot be turned off by a switch. Do
not use an extension cord.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, unplug wine cellar or
disconnect power.
Dispose of and/or recycle all packaging materials.
After all packaging materials have been removed,
clean the inside of your wine cellar. Refer the cleaning
instructions in "Cleaning" section.
NOTE: For standard stainless steel or glass door models,
skip to "Door Closing" section.