Product Dimensions; Custom Overlay Panel - Jenn-Air JUWFL242HL Guide D'utilisation Et D'entretien

PRODUCT DIMENSIONS

OVERALL PRODUCT
Width (up to hinge cover)
Height (up to hinge cover)
Glass door model (NOIR™) depth
(no handle)
Glass door model (RISE™) depth
(no handle)
Solid door models
(NOIR™/ RISE™)
Panel ready models depth
(with 3/4" panel and no handle)
Raw Door Height
NOTE: The power cord is 60" (152.4 cm) long.
237/8"
(60.72 cm)
343/8"
(87.32 cm)

CUSTOM OVERLAY PANEL

NOTE: For standard stainless steel or glass door
models, skip these instructions and go to "Electrical
Requirements" section.
If you plan to install a custom overlay panel, you will
need to create the panel yourself or consult a qualified
cabinetmaker or carpenter. Refer dimension drawings for
panel specifications.
IMPORTANT:
The thickness of the overlay panel must be 3/4"
(19 mm).
Custom solid door overlay panel must not weigh
more than 20 lbs (9.07 kg).
Custom glass door overlay panel must not weigh
more than 10 lbs (4.54 kg).
Overlay panels weighing more than recommended
may cause damage to your appliance.
6
SOLID DOOR OVERLAY PANEL — PREPARATION
Create the custom overlay panel using the dimensions
shown in the illustration "Solid door overlay panel and
237/8" (60.72 cm)
hinge routing dimensions". Route shaded areas to a 1/2"
(12 mm) depth as shown.
343/8" (87.32 cm)
IMPORTANT: The following graphic shows a custom
233/4" (60.36 cm)
panel for a door with the hinges installed on the right-
hand side. If your wine cellar has the hinges installed on
the left-hand side, rotate the custom frame 180° so the
235/8" (60 cm)
hinge markings will be on the left.
235/8" (60 cm)
2313/16" (60.5 cm)
305/8" (77.75 cm)
Depth
(no handle)
305/8"
(77.5 cm)
1/4"
(7 mm)
1/8" 415/16"
(3 mm) (125 mm)
1/2"
(12 mm)
Solid door overlay panel and hinge routing dimensions
2"
(53 mm)
233/4"
(60.3 cm)
305/8"
(77.75 cm)