Stocking The Wine Cellar; Wine Racks - Jenn-Air JUWFL242HL Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STOCKING THE WINE CELLAR

NOTE: For optimum wine storage, place white wines at
the top of the wine cellar, light red wines in the center
and champagne/larger diameter wine bottles at the
bottom.
1
2
3
4
5
6
Racks 1-5: For storing up to eight 750 ml wine bottles
[diameter less than or equal to 31/8" (80 mm)]
Rack 6: For storing up to five larger wine bottles
[diameter up to 33/4" (95 mm)]
TO STOCK THE WINE CELLAR - RACKS 1 TO 5
NOTE: The wine rack can be stocked with the bottles
facing either direction, however, to optimize storage
adjacent bottles should be facing in opposite.
1.
Start stocking the wine cellar with the bottom display
rack (5).
2.
Starting on the left-hand side, place the first
on the bottom of the rack with the neck of the bottle
facing the front of the wine cellar.
3.
Place the next bottle on its side with the neck of the
bottle facing the back of the wine cellar. Alternate
the direction of the bottles, in this manner, until the
display rack is full.
4.
Slide the bottom rack into place and pull the next
rack (4) forward.
5.
Continue stocking each remaining rack as described
in the above steps.
TO STOCK THE WINE CELLAR - RACK 6
1.
Starting from left-hand side of the bottom rack, place
the first bottle with the neck of the bottle facing the
front of the wine cellar.
2.
Continue to place the remaining bottles facing in the
same direction.

WINE RACKS

REMOVE AND REPLACE THE RACKS
1.
Pull the rack forward until it stops.
2.
Press down on the left-hand lever while lifting up on
the right-hand lever to release the rack. Pull the rack
forward and lift it up and out of the rack supports.
3.
bottle
Replace the rack by inserting the rack into the
supports and sliding it in until it locks.
A
A. Lever
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Juwfl242hm

Table des Matières