How Does It Work - Marmitek Invisible Control 4 Guide Utilisateur

3. HOW DOES IT WORK?

Remote control
Place the Invisible Control 4™ within sight, on or below the cabinet that the A/V equip-
ment is in. Stick the IR LEDs on the IR eye of your equipment and then wire these to the
Invisible Control 4™. The Invisible Control 4™ now receives the signal from your own
remote control and transmits it to the IR LEDs connected to your equipment. You can
now use your own remote control to operate your equipment while it is still placed in a
closed cabinet.
4. INSTALLATION
1. Plug the power adapter into the back side of the Invisible Control 4™ or insert 4
pieces 'AAA' size ALKALINE battery (not included) into the battery compartment
with correct polarity.
2. Connect the wire with the two IR LEDs (the IR extender) to the back side of the
Invisible Control 4™. It doesn't matter whether you use the first or the second con-
nection.
3. Place the Invisible Control 4™ within sight and within reach of your remote control
(max. 8 m) on or below the cupboard the equipment is in.
4. Lead the wire with the IR LEDs (the IR extender) to the A/V equipment in such a way
that the IR LEDs (transmitters) are on the front of your equipment (e.g. via the back
of the cabinet). The IR LEDs have self-adhesive tape on the back. Use this to stick
them onto the IR sensor of your equipment. This should be done very carefully and
precisely. Test the position of the IR LEDs first, before you stick them onto the sensor.
ATTENTION: If you are only using one appliance, then you do not need to
use the second IR LED. Never remove it from the wire!
5. The Invisible Control 4™ receives the signal from your remote control and transfers
it to an electrical signal, which is passed on to the IR LEDs.
6. This means all signals from your remote control are passed on to your equipment.
4
A/V-devices in
closed cabinet
Place the IR LED's on the IR display panels of the A/V-devices
Invisible Control 4
LEDs IR
© MARMITEK