Attachment - EuroLite WDL Série Mode D'emploi

WDL-2005
Step 1: Remove the luminaire cover.
Step 2: If replacing a defective tube, remove the old tube from the socket.
Step 3: Insert the new tube into the lamp-socket and swivel it.
Step 4: Replace the luminaire cover
WDL-2016
Step 1: Carefully remove the glass cover.
Step 2: If replacing a defective tube, remove the old tube from the socket.
Step 3: Insert the new tube into the lamp-socket and swivel it.
Step 4: Replace the glass cover.

Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
As many luminaries of a single series can be connected via the plug/coupler connector until a total power
Procedure:
WDL-2004B
Remove the mounting clips (2 versions) and screws included in delivery from the packaging and use
whichever clips are most suitable for the desired mounting area.
Schritt 1: Hold the clips onto the location where the device is to be installed.
Schritt 2: Mark the boreholes with a pen or a suitable tool.
Schritt 3: Drill the holes.
Schritt 4: Screw the suitable clips into the installation surface.
Schritt 5: Press the luminary carefully into the mounting clips until it clicks and the device is firmly fixed.
WDL-2005
Step 1: Carefully remove the luminaire cover.
Step 2: The holes for the installation are on the the inside of the luminaire.
Step 3: Hold the luminaire onto the location where the device is to be installed.
Step 4: Mark the boreholes with a pen or a suitable tool.
Step 5: Drill the holes and screw the included screws into the installation surface.
Step 6: Hold the luminaire in the desired position and fix it with the included screws.
Step 7: Carefully replace the luminaire cover.
consumption of 120 W is reached
15/35
00024554.DOC, Version 1.0