Stand-Alone Mode - Velleman HQ POWER VDPL710MHW14B Mode D'emploi

Colour Adjustment
You can adjust the brightness of the red, green, blue, and white LEDs to set the desired output colour.
To adjust the colour:
1. Press <MODE/ESC> once to enter menu mode (<Addr> is displayed).
2. Press and hold <ENTER> for about 5 seconds until <BALA> is displayed.
3. Press <ENTER> again.
4. Use <UP> and <DOWN> to select the LED colour that you want to adjust: <Red> for the red LEDs,
<Gree> for the green LEDs, <Blue> for the blue LEDs, and <Whit> for the white LEDs. Press
<ENTER> to confirm.
5. Use <UP> and <DOWN> to set the brightness (0-255) of the selected colour and press <ENTER> to
confirm.
6. Press <MODE/ESC> to quit.
Standby Mode
If you are working with a DMX controller, the signal cable may be (accidentally) disconnected, or the
controller may be (accidentally) switched off. In this case, you can define how the device responds:
either the device stops (stand-by), or it starts running the built-in program.
1. Press <MODE/ESC> until <STBY> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to select the desired setting:
o <Yes>: the device stops if there is no DMX signal.
o <No>: the device starts running the built-in program if there is no DMX signal.
3. Press <ENTER> to confirm.
Reset Position
It may happen (for example because of a power surge) that the device deviates from the correct neutral
pan/tilt position (pan and tilt = 0°).
To reset the moving head to the correct neutral position, press <MODE/ESC> until <RSET> is displayed
and press <ENTER>. The moving head corrects its position.
Test Mode
You can run a test programme to check if all LEDs are functional.
1. Press <MODE/ESC> until <TEST> is displayed and press <ENTER>.
The device runs a test programme. During the test, "test" blinks on the display.
2. Press <ENTER> to quit.
Operation Time
The device counts the time the lights have been operational.
1. Press <MODE/ESC> until <HOUR> is displayed and press <ENTER>.
The display shows the operation time in hours.
2. Press <MODE/ESC> to quit.
7.3

Stand-Alone Mode

In stand-alone mode, the device runs a built-in program: automatic or sound-activated.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input [3] of the device.
2. Press <MODE/ESC> until <SLND> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to select <MAST> and press <ENTER> to confirm.
4. Press <MODE/ESC> until <AUTO> is displayed and press <ENTER>.
5. Use <UP> and <DOWN> to select the desired setting:
o <Yes>: the device runs the built-in program.
o <No>: the device operates as a master device in sound-activated mode.
6. Press <ENTER> to confirm.
Setting the Microphone Sensitivity
For sound-activated mode, you can adjust the sensitivity of the internal microphone. To change the
sensitivity of the internal microphone, proceed as follows:
1. Press <MODE/ESC> until <SOUN> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to change the sensitivity (0-100) and press <ENTER>.
V. 01 – 26/03/2013
VDPL710MHW14B/VDPL710MHW14W
6 ©Velleman nv