Wiring Diagram - Hendi Arktic 271575 Mode D'emploi

Timer Setting
How to set the timer: When the machine is off,
press the "Timer/Clean" button to set the time
when the machine has to turn on. The "Timer" light
will go on, the number in digital window will flash
to display in how many hours the machine will go
on. During the number flashing, press
button to add or remove hours, the default setting
is zero. Five seconds after setting, your desired
setting will be programmed.

Wiring diagram

ELECTRICAL
DIAGRAM
FPR ICE-MAKER
Power
Supply
DC Fan Motor
Main CONTROL PCB
Normal Sounds
Your new ice maker may make sounds that are not
familiar to you. Most of the new sounds are normal.
Hard surfaces like the floor, walls and cabinets can
make the sounds seem louder than they actually
are. The following describes the kinds of sounds
that might be new to you and what may be making
them.
,
Start relay
COMPRESSOR
Overload
Protector
Relay
How to cancel the ON-Timer: Press the "Timer/
Timer" button, the number in digital window will
flash to display the present delay time of your
ON-Timer, and press the button again to cancel the
setting. Pressing the " " button will also cancel
the timer.
How to cancel the OFF-Timer: This is the same
procedure as for canceling the ON-Timer.
Water Timer Power
UP
DN
BUTTON CONTROL PCB
VALVE PUMP
WATER
ICE
• You will hear a swooshing sound when the water
valve opens to fill the water tank for each cycle.
• Rattling noises may come from the flow of the
refrigerant or the water line.
• The high-efficiency compressor may make a pul-
sating or high-pitched sound.
• Water running from the water tank to the evapo-
rator plate may make a splashing sound.
Full Clean
on/off
timer/set
AC Water Pump
Solenold Vale for
Ice-harvest
DC Water Inlet Valve
WATER LEVEL
DETECTING SWITCH
SENSOR FOR
AMBIENT TEMP
SENSOR FOR
SUCTION TUBE TEMP
SENSOR FOR
ICE FULL DETECTING
EN
13