Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electrical requirement & connections
WARNING: THIS UNIT MUST BE EARTHED.
• Before you move your ice maker into its final lo-
cation, it is important to make sure you have the
proper electrical connection.
• It is recommended that a separate circuit, serv-
ing only your ice maker, be provided. Use recepta-
cles that cannot be turned off by a switch or pull
Cleaning your ice maker befroe first using
1. Open the door.
2. Clean with diluted detergent, warm water and a
soft cloth.
3. Repeatedly clean the water contacting inner
parts, you can pull the Water drain pipe of the
water tank indicating "H" in above illustration to
drain the cleaned water in the water tank, next
clean the inner ice-storing cabinet. After that
drain out all of the cleaning water from the water
drain port located at the back of the unit ("7"in
Water connection for your ice maker
Important: Be sure to use the new hose-sets sup-
plied with the appliance.
Connect the water supplying hose to the unit
Step 1: First remove the clipper on the water inlet
port (indicated in the following illustration
"B") located at the back of the unit. Remove
the anti-dust plug.
Connecting the water drain pipe
Pull out the water drainage cap with black color
(indicated "A" in above illustration), then connect
the white drainage pipe included in accessory, con-
chain. If the supply cord or plug to be replaced,
it should be done by a qualified service engineer.
• This appliance requires a standard 220-240
Volt, 50Hz electrical outlet with good grounding
means.
above illustration). Reinstall the water drain pipe
and the cap of the water drain port, otherwise,
the unit will not work properly. Discard the first
ice-cube after cleaning.
4. The outside of the ice maker should be cleaned
regularly with a mild detergent solution and
warm water.
5. Dry the interior and exterior with a clean soft
cloth.
Step 2: Insert the one end of the white water hose
into the water inlet port, and push inward
completely, and install back the clipper,
then water hose connection is completed.
Step 1: Remove the
anti-dusty plug
Water inlet port on the
unit back
Remove the
Remove the
clipper first
clipper first
Press inward the active
out circle, then remove
the anti-dusty plug.
nect the other end of this drainage to the main wa-
ter drainage pipeline.
Step 2: Insert the water
hose
Then install back the
clippe
White water hose
(accessory)
First insert the
water hose inward
completely
EN
11
Publicité
Table des Matières
