Description; Display Illumination; Status Indicator - Hilti PS 35 Mode D'emploi

Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
en

2 Description

2.1 Use of the product as directed
The Hilti PS 35 Ferrodetector is designed to detect ferrous metals (steel rebars), non-ferrous metals (copper and
aluminium) and to measure the depth of concrete cover.
The tool is not suitable for locating the position of tensioning cables.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Take the influences of the surrounding area into account. Do not use the tool or appliance where there is a risk of fire
or explosion.
Modification of the tool is not permissible.
2.2 Display
The measurements, settings and tool status are shown in the display.

2.3 Display illumination

The display illumination switches on automatically in conditions of low ambient light.
2.4 Display
Areas of the display
2.5 Standard settings in the status area
Standard status area

2.6 Status indicator

Status area
14
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
1
2
Shows the two areas of the display.
The standard detection mode is set automatically when the tool is
switched on. In this mode, ferrous metals and non-ferrous metals
(copper and aluminium) can be detected. Limited depth scan is switched
off.
1 2 3 4
Shows which status is active
Status area
@
Detection area
;
Ferrous metal detection is act-
ive
@
Non-ferrous metal detection is
5 active
;
Limited depth scan is active
=
Selected depth measurement
range (in mm or inches)
%
Battery status
&