Adjusting The Commander's Operating Environment - Sony RM-TP1 Mode D'emploi

Changing the name of the remote
(component) (continued)
2
Touch the remote (component) you
want to change the name ("VIDEO1" for
example).
Or, turn the jog dial to select the remote
(component), then press the jog dial to enter
the selection. The screen for operating the
component appears.
3
Touch
The pull down menu appears.
4
Touch NAME EDIT in the pull-down
menu.
The RM NAME EDIT screen appears.
Current name display
Name input display
Name input buttons
5
Enter the name you want.
6
Touch SET.
The new name is set in the commander.
7
Touch EXIT.
GB
30
.
Adjusting the
commander's operating
environment
The RM SETUP screen allow you to adjust
various settings and customize the
commander's operating environment.
1
Touch RM SETUP.
The RM SETUP screen appears.
2
Touch the menu you want to adjust.
See below for details about each menu.
3
Touch EXIT to return to the RM SETUP
screen.
x Adjusting the contrast of the display
(CONTRAST)
You can adjust the contrast of the display.
Touch + or – to adjust the contrast.
Tips
• Depending on the brightness of the room and the
angle at which the commander is viewed, the LCD
may be difficult to see. When this occurs, changing
the angle of the commander or adjusting the
contrast of the LCD may make the LCD easier to
see. When fingerprints (etc.) get on the LCD, wipe
the LCD with a soft, dry cloth. It is recommended
to use the touch pen supplied with the commander.
• The contrast lightens a little when the temperature
lowers, and darkens a little when the temperature
rises.
Current setting