dirna Bergstrom bycool blue line FLAT Instructions De Montage page 26

FLAT
ES
EN
Place console and centre equipment in the most
11
convenient place of cabin roof. Once centred,
remove console for later installation.
Fasten supports tightening nuts until outside
12
EPDM joint of equipment is compressed,
between 3 and 6 mm; the meeting must be
with a thickness between 19 and 22 mm
Important: To avoid water from filtering
inside cabin, check EPDM joint tightening
with base, as indicated on diagram.
12
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is compressed
between 3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
13
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
11
12
Base
Support
13
26
Check compression
thickness using a
tape measure in the
four corners.
EPDM gasket
®
12