Mounting Guidelines - dirna Bergstrom bycool blue line FLAT Instructions De Montage

FLAT
Mounting
Guidelines
• Prior to assembly, read the instructions and follow these
throughout the mounting operations.
• Use the appropiate tools for each operation.
Electricity
• Switch the connector off.
• Disconnect the battery before starting mounting
operations.
• Verify that the electrical components have been
connected correctly.
References to position:
RIGHT: Driver's right hand
LEFT: Driver's left hand
Driving torques (N.m)
Steel Quality
Fillet
8.8
M4/60 2.9
M5/80 5.5
M6/100 10
Important
!
Evaporative air conditioner works by taking air
from outside and introducing it in cabin. It is
essential that air does not stagnate inside, which
would produce an excess of humidity. All modern
cabins of vehicles are equipped with air inlets,
through which required air comes out as, for
instance, in the case of heating.
Assembler will have to check that these air inlets
do exist and, in case they do not, he will have to
mount them.
As for the user, he will have to periodically
make sure that these air inlets are not blocked
by dirt.
Wrench
opening
10.9
4.2 7
7.5 8
13 10
19
Tools
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10
Open-jawed spanner 13
Open-jawed spanner 14
Scissors
Flexo-meter
Documentation included
Mounting instructions
User's guide
Troubleshooting
Included parts
Warranty
Important
!
The following parts will have to be delivered to
user: Winter cover and user's handbook.
The assembler is recommended to read the above
mentioned handbook, before giving it to user, in
order to inform himself of the maintenance and
recommendations on the evaporative equipment
being assembled.
!
Warnings
! Dirna Bergstrom, s.l. will not be held
responsible for any faults arising from
inappropriate handling or installation of
the equipment, or due to modifications or
replacements carried out without our written
authorisation.
EN ES
®
220.AA3.5040
220.AA7.0003
220.AA7.0004
220.RE0.0129
220.AA1.0010