ROSIERES RVM 324 Notice D'emploi Et D'installation page 37

• STOPPING A COOKING ZONE
The cooking zone must be live. In the display zone, the control LED must be on. If not, select
the required zone again.
. Press the button to display heat level
goes off after 10 seconds.
. To stop rapidly, press the
tically goes down to
• GENERAL STOP
The cooking zones and the timer can be stopped at any
moment by pressing for 3 seconds on the On-Off button.
• RESIDUAL HEAT INDICATOR
The control panel tells the user when the surface temperature of the cooking zones exceeds
about 60°C, by the following displaying:
For ending the cooking, we advise switching off the cooking zone and using the residual
heat of the zone to finish cooking gently.
When the temperature goes back below 60°C, the
N.B. After a cut in the current, the residual heat indicator disappears completely, even if the
surface temperature exceeds 60°C.
• OPERATING THE ADDITIONAL COOKING ZONE
An additional cooking zone is fitted to certain hob models. It can be either concentric
or extendable. To start the additional cooking zone:
. Press the button
. Press the button for the zone with the addition. In the display zone, the blinking lamp
goes steady. It shows that the zone is live.
. Select a heat level between 1 and 9.
. Press the button
and buttons at the same time. The heat level automa-
. The cooking zone goes off.
. In the next 10 seconds,
to start the additional zone.
. Now the zone goes off, the indicator
.
display goes off.
- 37