Fitting - ROSIERES RVM 324 Notice D'emploi Et D'installation

INSTALLATION – FITTING
The unit or support for the hob, as well as the walls of any adjacent units, must be made of
high temperature resisting material. In addition, the laminate covering the unit or support
should be laid using heat-resistant adhesive to prevent it coming away.
Installation:
• A seal is supplied with the hob. To install it,
. turn over the hob, glass side down, taking care to protect the glass.
. place the seal all round the hob.
. make sure it is placed correctly to prevent any ingress into the support unit.
SEAL
Hob with glass
side down
• The body of the hob is fitted with 4 locations holes to take the fixing clamps intended to fix
the hob in the unit. Place the 4 fixing clamps, in such a way that the hob is placed perfectly
in the support unit.
• Leave a gap of at least 5 cm between the appliance and any neighbouring vertical surfaces.
• If, according to the hob's installation, the casing bottom is near a zone normally accessible
during handling and/or storage, install a partition 1 cm from the casing bottom, to prevent
any risks of burns or deterioration.
---------------------------------------------------------------------------------------------------------------------------
• VITROCERAMIC HOB WITH CONTROL KNOBS
HOB: width 60 cm
30 -
HOB CASING
opening 10 X 10 cm
for the power supply
Hob frame
HOB: width 34 cm