Troubleshooting; Warranty - SilverCrest SWCD 1000 A1 Mode D'emploi

Troubleshooting

Problem
The appliance
does not function.
The appliance
does not get hot.

Warranty

The warranty for this appliance is for 3 years from the date of purchase. The appli-
ance has been manufactured with care and meticulously examined before delivery.
Please retain your receipt as proof of purchase. In the event of a warranty claim,
please make contact by telephone with our Customer Service department. Only
in this way can a post-free despatch for your goods be assured.
NOTICE
► The warranty covers only claims for material and manufacturing defects,
it is not applicable for transport damages, parts subject to wear and tear
or for damage to fragile components, e.g. bulbs and switches.
This appliance is intended solely for private domestic use, not for commercial ap-
plications. If this product has been subjected to improper or inappropriate han-
dling, abuse, or modifi cations not carried out by one of our authorised service
centres, the warranty will be considered void.
Your statutory rights are not restricted in any way by this warranty. The warranty
period is not extended by repairs made under the warranty. This applies also to
replaced and repaired parts.
Damages and defects extant at the time of purchase must be reported immedi-
ately after unpacking, resp. no later than two days after the date of purchase.
Repairs made after the lapse of the warranty period are subject to charge.
SWCD 1000 A1
Cause
• The plug is not inserted
into a power socket.
• The appliance is not
switched on.
• The appliance is defec-
tive.
• The slider switch Cool
Shot 2 is in the upwards
position.
• The appliance is
defective.
Remedy
• Insert the plug into a
mains power socket.
• Switch on the
appliance.
• In this case, contact
Customer Services.
• Slide the slider switch
Cool Shot 2 down-
wards.
• In this case, contact
Customer Services.
GB
47