Maintenance And Care; Fuse Replacement - Renkforce RF-RUDAB1805 Notice D'emploi

Establishing a phone call
• Dial the desired phone number on your mobile phone.
• The car radio will automatically switch to Bluetooth
Ending a phone call
• Press the button F/PS/
Audio streaming
Audio streaming is the transmission of audio data (music) by Bluetooth
If you have an A2DP-capable mobile phone, you may connect it to the car radio by pairing as described above and
establish an audio transmission.
• Ensure that the two devices are connected by pairing.
• Start playback at your mobile phone (see corresponding operating instructions).
• Push the button MOD/TA/
• The audio transmission is now active.
• You can now remote-control playback of your mobile phone with the buttons
during playback from USB or SD storage media.

11. Maintenance and Care

• Check the technical safety of the car radio regularly, e.g. for damage to the connection cables or to the casing.
• If it can be assumed that safe operation is no longer possible, the device must be turned off and precautions are to
be taken to ensure that it is not used unintentionally. Disconnect the car power system!
a) Fuse Replacement
• If you have to replace the fuse, ensure that you only use fuses of the specified type and rated current (see "Technical
Data") as a replacement.
Never repair fuses or bridge the fuse holder.
• When the power supply has been disconnected (disconnect ISO plug!) carefully remove the fuse from the fuse
holder next to the ISO plug.
• Replace it with a fuse of the same type.
• After this, you can reconnect the car radio to the board mains and take it into operation.
• Should the fuse trigger again, have the car radio repaired in a specialised workshop.
54
®
(2) to terminate a call.
(3) until BT AUDIO is shown in the display (4).
mode and show CALL OUT in the display (4).
to the car radio.
®
(1), (8) and 1/ (11) as