Convenience Functions - Waeco MagicSafe MS620 Instructions De Montage Et De Service

MS-620.book Seite 76 Dienstag, 18. Oktober 2005 3:04 15
Programming MagicSafe
10.2 Using convenience functions

Convenience functions

MagicSafe has an output for convenience functions which sends an earth signal when
activated. You can use the following convenience functions:
No. Function
1 Convenience output
If you press button 2 when the alarm system is activated, MagicSafe switches on an
earth signal for 1 s which can be a maximum of 350 mA.
This enables you to operate additional functions, for example:
– Closing electric windows and/or the sun roof
– Switching on the parking heating
– Switching on the main beam light
– Unlocking the boot or the fuel tank lid
2 Pager output (radio alarm pager)
If an alarm is triggered, a constant earth signal is output for the duration of the alarm.
3 Control signal for horn relay
If an alarm is triggered, a pulse earth signal is output for the duration of the alarm.
4 Automatic convenience output (window close)
After the alarm system is activated, an earth signal is sent for approx. 30 s.
5 Interior lighting delay
After the alarm system is deactivated or the vehicle is opened, an earth signal is sent for
approx. 20 s.
You may require additional modules for some of these functions.
You can obtain further information on this from WAECO.
10.3 Programming
The PIN code set at the plant is 1.
Starting the programming mode
➤
Switch the ignition on and off twice.
➤
Switch on the ignition again within 7 s.
✓
The status LED flashes for 3 s. Afterwards there is a pause of 1 s.
➤
Count how often the status LED flashes and switch off the ignition when the number
of flashes corresponds to your PIN code.
If the "Locking/unlocking with ignition" software function is active,
MAGIC SAFE locks the central locking while the PIN is being entered.
➤
Switch the ignition on again.
76
MagicSafe MS620