Searching For Errors; Guarantee/Repairs; Disposal - Waeco MagicSafe MS620 Instructions De Montage Et De Service

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 81
MS-620.book Seite 79 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
12

Searching for errors

The range of the remote control is decreasing.
The batteries are flat.
You have lost the remote control or it has been damaged.
Switch the alarm system off using your PIN code (see "Deactivating MagicSafe with-
out the remote control" chapter on page 70).
You will hear three signal tones/flashing signals instead of the usual indications
when you switch the alarm on.
The alarm system is warning you that a door or the bonnet or boot is open.
Switch the alarm system off.
Rectify the cause of the error message.
Switch the alarm system on again.
Program software function 8 "Interior lighting delay" to "ON".
You hear four signal tones/flashing signals instead of the two signals when you
switch the alarm off.
The alarm system has triggered an alarm.
Count the number of flashes on the status LED.
This indicates the sensor which has triggered the alarm (see corresponding table in
"Warning signals" chapter on page 74).
You switched off the alarm system a few minutes ago, but the alarm system has
switched itself back on again.
The alarm system has possibly detected that you have not entered the vehicle and has
therefore automatically switched itself on and locked all the doors if this option has been
selected (software function 1 "Self-activation").
Leave a door or the bonnet/boot open to avoid this.
13

Guarantee/repairs

Our general guarantee conditions apply. If the product is defective, please send it back to
the WAECO branch in your country (addresses on the back of the instruction manual) or
to your specialist dealer. For repair and guarantee processing, the following documents
must be sent along with the device:
Copy of the receipt with purchasing date
A reason for complaint or description of the fault
14

Disposal

Place the packaging material in the appropriate recycling waste bins wherever
possible.
If you need to scrap the device, ask your local recycling centre or specialist
dealer for details about how to do this in accordance with the applicable disposal
regulations.
Searching for errors
79

Publicité

Table des Matières
loading

Table des Matières