Waeco MagicSafe MS620 Instructions De Montage Et De Service page 72

MS-620.book Seite 72 Dienstag, 18. Oktober 2005 3:04 15
Using MagicSafe
9.7 Using the self-activation function
If you have set software function 1 ("Self-activation") to "ON" , MagicSafe will activate
itself as follows:
➤
Switch the ignition off.
➤
Open the door and get out of the vehicle.
➤
Close the door again.
✓
The hazard lights flash twice.
✓
The status LED flashes quickly.
➤
Do not open a door or cover for the next 30 s.
✓ The alarm system activates itself.
If you have set the system to self-activate, the central locking does not lock
the doors, to prevent you locking yourself out of the car by accident.
If the central locking is to be activated, you need to select software function 6 ("Locking
on reactivation").
9.8 Controlling the central locking with MagicSafe
Automatic locking when the ignition is on
If you have selected this function, MagicSafe locks all doors automatically when you
switch on the ignition. This function protects you against attacks.
If you open a door when the ignition is on, before the closing signal has been
sent, the closing signal is no longer issued to prevent you from locking yourself
out of the vehicle accidentally.
Locking/unlocking the vehicle from the interior
This function enables you to lock or unlock the doors when you are inside the vehicle. The
ignition must be switched on for this.
➤
Press button 1 on the remote control to lock the doors or ...
Press button 2 on the remote control to unlock the doors.
The doors are automatically locked if you switch the ignition off.
72
MagicSafe MS620