Using Magicsafe; Operating The Remote Control - Waeco MagicSafe MS620 Instructions De Montage Et De Service

MS-620.book Seite 68 Dienstag, 18. Oktober 2005 3:04 15

Using MagicSafe

If the central locking is not working properly, proceed as follows:
➤
Check the electrical connection to the central locking.
➤ Check if your vehicle supports software function 4 ("Impulse duration of the door
locking function").
➤
Check which value has been set for software function 4 (see "Programming" chapter
on page 76).
8.4 Testing optical and acoustic signals
During the alarm all indicators must be switched on and the alarm siren and the status
LED must signal the alarm.
8.5 Testing the automatic reactivation
➤ Activate the alarm and then deactivate it again.
➤
Do not open a door or the bonnet or boot.
MagicSafe must activate itself after approx. 90 s, without locking the doors.
8.6 Testing the remote control
➤
Test all of the switching functions with both remote controls.
If the system does not respond to a remote control unit, program the affected remote con-
trol unit (see "Programming a new remote control" chapter on page 78).
The range of the remote control can be limited by solid metal parts and strong
electrical fields, it is usually between 10 m to 20 m.
9 Using MagicSafe
9.1

Operating the remote control

The two remote control units supplied have two buttons and one LED.
No. in
Fig. 7, page 6
1
2
3
The LED flashes when you press one button or both buttons simultaneously.
68
Description
Button 1
Button 2
LED
MagicSafe MS620