Dometic DVF Holding Tank Vent Filter Instructions De Montage Et De Service page 6

Inserting the filter
4.2 Inserting the filter
➤ Grease the O-ring on each connector of the vent filter using a lubricant or silicone
grease.
➤ Remove the red stoppers from both connectors of the vent filter.
➤ Select a suitable adapter:
No. in
fig. 3,
Description
page 2
5a Adapter for thread with Ø 16 mm or 19 mm
5b Adapter for hose with Ø 16 mm or 19 mm
5c Adapter for hose with Ø 25 mm or 38 mm
➤ Screw the selected adapter together with the hose couplings (fig. 2 3, page 2)
on the vent filter.
➤ Insert the vent filter into the holder so that it latches into place.
For using thread adaptors only
➤ Check that there are seals (not included in delivery) in the connectors of the
hoses.
➤ Connect the vent hose from the tank (fig. 4 3, page 3) and the vent hose to the
hull vent pipes (fig. 4 1, page 3) with the vent filter (fig. 4 2, page 3).
➤ Tighten the connectors by hand.
➤ Tighten the connectors further by a 1/4 to 1/2 a turn using a tool.
For using threadless hose adaptors only
➤ Connect the vent hose from the tank (fig. 5 4, page 3) and the vent hose to the
hull vent pipes (fig. 5 1, page 3) with the vent filter (fig. 5 3, page 3).
➤ Secure the vent hoses on the adapters with hose clips (fig. 5 2, page 3).
6
DVF
EN