System Cleaning, Care And Storage - Gaymar Plexus Auto Aire Select Manuel D'emploi

13.0

System Cleaning, Care and Storage

13.1 Cleaning
•
Disconnect the AC power cord from the wall outlet before attempting to clean the control
unit. Failure to disconnect the AC power may result in risk of death or serious injury.
•
Do not heat or steam autoclave any component of the system. Damage may result.
13.1.1 To clean, use soap and a clean damp cloth to wipe down the control unit, power cord, hoses and
mattress. Do not use abrasive cleaners on the mattress. Wipe dry with a clean, dry cloth. Note:
Blood and other body fluids must be thoroughly cleaned from all surfaces before applying
disinfectants.
13.1.2 Apply any approved disinfectant to the external surfaces of the control unit, hoses and mattress.
Allow to completely dry. The solution contact time is what makes disinfection effective
13.1.3 Wipe down the mattress with a clean, dry cloth to remove any excess disinfectant.
13.1.4 The top sheets of the Auto Aire Select series of mattresses may be laundered between patient
uses or as required to maintain good patient hygiene. Fill the washing machine with warm water
(70 -140 °F or 21 - 60 °C). Add one cup of laundry detergent. Place no more than four top
sheets in a single extra large load capacity washing machine. When wash cycle is complete,
remove promptly from machine and ensure all excess water is drained from load. Place dryer on
LOWEST heat setting, or AIR FLUFF if available until dry. Verify top sheet is completely dry
before placing under patient.
13.1.5 If individual air cells of mattress become soiled, clean and disinfect as described above or simply
replace air cell with a clean replacement. Single air cell replacement can be successfully
achieved with patient remaining on the mattress.
Do not launder the red colored Active Sensor Technology air cells of the of
the M2500S mattress or Aire Select Safety Mattress. Damage may result.
WARNING
WARNING
10
Auto Aire Select™