Clatronic WKS 3744 G Mode D'emploi page 30

• Only use the appliance in a dry, indoor area. It is intended for do-
mestic use and similar areas of use such as e. g.:
- In staff kitchen areas in shops, offices and other working envi-
ronments;
- By guests in hotels, motels and other residential type environ-
ments.
It is not intended for use in farm accommodation or Bed & Break-
fast establishments.
• The following symbols are on the product:
CAUTION:
Do not immerse the appliance into water for cleaning. Please
follow the instructions as stipulated in the chapter "Cleaning".
Notes for Use
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Connected Wattage
The total power consumption of this appliance can be up
to 2200 W. With this connected load a separate supply line
protected by a 16 A household circuit breaker is recom-
mended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
Electrical Connection
1. Check whether the electrical voltage that you intend to
use is the same as that of the appliance. Details are to
be found on the label on the base.
2. Only connect the appliance to a properly installed safety
socket.
Switching the Appliance On / Off
Switch the appliance on and off via the O / I switch.
30
WKS3744 G_IM
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.
Use
NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Open the kettle using the integrated lever in the lid.
3. Then fill in the water (max. 1.7 Litre). You can read the
filling level on the water level indicator of the kettle.
4. Close the lid.
5. Place the kettle flush on the base.
6. Switch on the appliance.
Pausing / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1. The appliance will shut off automatically after the boiling
process.
2. Set the switch to the O position to pause or terminate the
boiling process.
CAUTION:
• Do not remove the appliance from the base without
shutting it off first. As long as the switch is in the I posi-
tion, the kettle will stay turned on.
26.07.19