Festo DGC Série Notice D'utilisation page 33

DGC−...
Fitting profile fastenings (centre supports)
type MUC−...:
1. Place the profile fastenings equally over
the entire length of the drive, and not just
over the stroke length.
2. Fasten the profile fastenings on the
DGC−... in accordance with Fig. 12.
3. Tighten the fastening screws to an
equal extent.
Tightening torques:
MUC−8/12
1.2 Nm
Fig. 13
4. Make sure that the profile fastenings are
outside the positioning range of the slide
(especially with side fastenings).
In order to do this push the slide once
over the entire positioning path.
Festo DGC−... 0604b English
MUC−18 MUC−25/32
4.1 Nm 8.3 Nm
Fig. 12
MUC−40
14 Nm
m
Fig. 14
33