Yamaha PW45 Notice Originale D'utilisation page 9

XVI - English
Structural changes on your S-Pedelec
Since the S-Pedelec is a motor vehicle there are several restrictions concerning structural changes. Table 1 indicates which compo-
nents can be replaced under which conditions.
Table 1: S-Pedelec components and conditions for replacement
Following components on our S-Pedelec can be replaced ...
a) only by original compo- b) without approval
1
nents
frame grips
drive unit shift lever
saddle
battery seat post clamping ring
chain
headset
tube
tyres (size as in CoC document and others approved by
Winora; have to be type approved)
bell
carrier (max. +15% of original dimensions, position of licence
plate holder must remain the same)
Note: max. carrier load is 15kg
mud guard (must correspond with the original dimensions
+/- 15%)
Approval of alternative components by Winora-Staiger GmbH
If it is necessary to replace original components due to damage or wear we recommend to use orinigal components. Please contact
your specialist dealer. Winora-Staiger GmbH provides its specialist dealers with a list of orinigal specifications. When replacing
components from table 1a) it is required to only use original components.
Furthermore there is a possibility to use alternative components for parts of table 1b) and 1c). You are relatively free when choosing
parts from column b) of table 1, you have to use components approved by Winora-Staiger GmbH when replacing parts from column
c) of table 1.
Please contact your Haibike / Winora specialist dealer about this matter.
Winora-Staiger GmbH provides its specialist dealers a regularily updated list with approved components.
In case of infringement according to column a) or c) the vehicle loses its type approval and must not be used
anymore.
it is required that the parts meet at least bicycle standard ISO4210 and a professional mounting.
1
c) only with offiial approval of
Winora-Staiger GmbH
fork
handlebar, brakes
stem
gear shift
chainwheel
cranks
reflectors
front / rear light (must have
same illuminance and must be
mounted on the same position)
mirror
seat post
stand
rims/hubs/wheels
licence plater holder
English - XVII