Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly Procedure
2) Fix with the 4 display installation screws
Tightening torque: 1.6 to 2.2 N•m
Note
● Do not install the display vertically using the pedestal.
3. Attaching the base
■
Base
● Position the convex part side at the front side of the
display.
1) Insert the base
to the pedestal tube.
● Make sure that the orientation of the front side and
back side of the base are correct.
● Be careful not to drop.
2) Fix the bases
(upper part) with the 2 base
installation screws
● Tighten the base installation screws from the outside
of the pedestal tube.
Tightening torque: 1.2 to 1.5 N•m
3) Using the 2 base installation screws
bases
(lower part) together with the 2 overturn-
prevention belts
and the 2 spacers
● Tighten the base installation screws from the outside
of the pedestal tube.
Tightening torque: 1.2 to 1.5 N•m
4) To stand the display vertically.
● Make sure to hold the display with more than two
people.
Note
● Be sure to attach the overturn-prevention belt when
attaching the base.
.
.
, fix the
.
(Cont'd)
Front of the display
Base installation
screw
Base installation
screw
Display installation screw
Convex part
Base installation
screw
Base
Specer
Overturn-prevention
belt
15
Publicité
Table des Matières
