LaserLiner MultiMeter-PocketBox Mode D'emploi page 13

standsmessung
smessung DC
ung
4
To measure the resistance, turn the rotary
switch to position „Ω".
Then connect the measuring contacts to
the object to be tested. The measured
Spannungsmessung DC
value acquired appears on the display.
If „O.L." appears on the display instead
of a measured value, either the measuring
range has been exceeded or the
measuring circuit is not closed or has
ngsmessung DC ngsmessung DC
been interrupted. Resistances can only be
measured correctly in isolation; therefore,
ssung
the components might need to be
disconnected from the remainder of the
circuit.
Widerstandsmessung
ng
andsmessung andsmessung
gangsprüfung
Spannungsmessung DC
When measuring resistance, to avoid the risk of the results
!
Durchgangsprüfung
angsprüfung angsprüfung
of a measurement being distorted, there must be no traces of
dirt, oil, solder spray or other contamination on the test prods.
ung
5
To test continuity, turn the rotary switch
gsprüfung
to position „
prüfung prüfung
switch once to activate the „Continuity
Diodenprüfung
test" function.
Widerstandsmessung
Then connect the measuring contacts to
the object to be tested. A measured value
of < 30 ohms is recognised as continuity;
this is confirmed by an audible signal.
If „O.L." appears on the display instead
of a measured value, either the measuring
range has been exceeded or the
measuring circuit is not closed or has
been interrupted.
Durchgangsprüfung
nprüfung
Diodenprüfung
MultiMeter-PocketBox
Resistance measurement
Continuity test
Spannungsmessung DC
" and press the „Mode"
Widerstandsmessung
Durchgangsprüfung
Diodenprüfung
black
Spannungsmessung DC
Spannungsmessung AC Spannungsmessung AC
Widerstandsmessung
Durchgangsprüfung
Diodenprüfung
Spannungsmessung DC
black
Widerstandsmessung
Durchgangsprüfung
Diodenprüfung
1x
red
Spannungsm
Spannungsmes
Strommessung Strommessung
red
Spannungsmessung AC
13
EN
S