Jenn-Air JUD278DBCX00 Guide D'installation page 7

Remove the Skids
IMPORTANT:
Always lay the appliance on its side when removing the skids.
Never place the appliance on its top. It may damage the
compressor.
Allow the appliance to sit on its rollers for 4 hours before
plugging into an electrical outlet.
1. Using two or more people, lay the appliance on its side.
2. Using a T30 TORX ®† screwdriver, remove the skids from the
bottom of the appliance. Discard the attachment bolts.
3. Using two or more people, turn the appliance upright on its
rollers.
When Moving Your Refrigerator Drawers:
Your refrigerator drawers are heavy. When moving the
appliance for service, be sure to protect the floor. Always
pull the appliance straight out when moving it. Do not
wiggle or "walk" the appliance when trying to move it, as
floor damage could occur.
Clean Before Using
After you remove all of the package materials, clean the inside of
your refrigerator drawers before using them. See the cleaning
instructions in the Use & Care Guide.
Remove the Base Grille
IMPORTANT: You must remove the base grille in order to lower
the leveling legs. Be sure to reinstall the base grille when the
installation is complete.
1. Using a Phillips screwdriver, remove the four screws from the
base grille as shown.
NOTE: Do not discard the screws.
A
2. Place the base grille on a clean, soft working surface for
later use.
†®TORX is a registered trademark of Textron Innovations Inc.
A
A. Screws
Style 2: Install Custom Overlay
Drawer Panels
If you have Style 1: Standard refrigerator drawers, skip this step.
Go to "Attach the Mounting Brackets to Adjacent Cabinets" to
continue the installation.
IMPORTANT:
Create custom overlay drawer panels according to the
specifications in the "Style 2: Custom Overlay Drawer
Panels" section.
Jenn-Air is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator drawers for service.
Remove the Wire Baskets
1. Open the drawer to full extension and remove all articles from
the wire baskets.
2. Pull the wire baskets out to full extension and lift out to
remove.
A
A. Wire baskets
3. Repeat the process for the other drawer.
Remove the Gaskets
IMPORTANT: The gaskets contain strong magnetic strips. Follow
these instructions and keep screws and other loose metal parts
away from the gaskets to avoid damaging them.
1. Begin at the top right corner. Slowly pull the gasket out of the
corner and continue working slowly toward the opposite side
as shown.
7