PROMAT 4000873349 Mode D'emploi Original page 12

 The power mains adaptor may only be used indoors in dry rooms.

 The torch is protected against low-pressure water jets (IP65). Do not
immerse it in liquids.
 The torch is impact protected (IK07). Nonetheless, avoid falls from a large
height.
 Do not disassemble the unit or attempt to modify or repair it yourself. It does
not contain parts serviceable by you.
Charging the Battery
Use the included USB charging cable to connect the charging socket (4) of the
lamp to a suitable USB port or use the included power mains adaptor to connect it
to a suitable wall socket..
During charging the charge indicator lights (2) at the rear of the torch light up green
one after the other and then switch to continuous green. After the charging process
has finished, all three LEDs are continuously lit green.
After the charging process has ended, disconnect the torch from the charging
cable.
Use
 Press the ON/OFF button once to switch on the light panel with reduced output
(100 lm). Press the ON/OFF button again to switch the light panel to half-output
(350 lm). Press the ON/OFF button once again to switch the light panel to full
output (700 lm). Press the ON/OFF button again to switch off the torch.
 Use the magnetic base (5) to attach the torch to magnetic surfaces or
components.
Maintenance and Storing
Do not use aggressive chemicals, solvents or abrasives to clean the torch. Do not
allow liquids of any kind to enter the torch or immerse the torch in liquids of any
kind.
Store the torch in a place away from direct sunlight, dust, humidity, extreme
temperatures and vibrations and out of the reach of children.
3
Operation