Before connecting the appliance to
the mains supply, leave it stand for
about 2 hours which will reduce the
possibility of malfunctions in the
cooling system that might have occurred due to
transport handling.
Clean the appliance thoroughly, especially the
interior (see Cleaning and Maintenance).
Instructions for Use
These instructions for use were prepared for the
user. They describe the appliance and its correct
and safe use. They were prepared for various
types/models of appliances therefore you might find
in it description of some functions and accesories
that do not apply to your appliance.
Mounting Instructions
Integrated appliances are equipped with instructions
for mounting the appliance into the kitchen unit.
The appliance should be professionally mounted by
qualified technician and instructions are for his use
only.
We Care for the Environment
Our products use environmentally friendly
packaging, which can be either recycled or
disposed of in an environmentally friendly
manner. To this end, individual packaging
materials are clearly marked.
These instructions are printed either on recycled
paper or chlorine free bleached paper.
When your appliance finally wears out, please try
not to burden the environment with it; call your
nearest authorised service agent. (See Disposing
of the Worn Out Appliance)
Tips for Energy Saving
Try not to open the door too often, especially
when the weather is wet and hot. Once you open
the door, mind to close it as soon as possible.
This is especially important if you have an upright
model.
Every now and then check if the appliance is
sufficiently ventilated (adequate air circulation
behind the appliance).
Turn the thermostat knob from higher to lower
setting as soon as possible (depends on how
loaded the appliance is, ambient temperature...)
Never use continuous operation unless
unnecessarily required; switch the operation
mode selection switch to the setting for
automatic operation as soon as possible.
Before freezing packages of fresh foods, make
sure they are cooled to ambient temperature.
(except for the soup)
Ice and frost layer increase energy consumption,
so do clean the appliance as soon as the layer is
3-5 mm thick.
If the gasket is damaged or if it turns out
that the sealing is poor, the energy consumption
is substantially higher. To restore efficiency,
replace the gasket.
The condenser on the rear wall should be always
clean, free of dust or any impurities.
Always consider instructions stated in sections
Positioning and Energy Saving Tips, otherwise
the energy consumption is substantially higher.